By continuing use this site, you agree to the Terms & Conditions and our use of cookies.
    Tank Standard For Sputnik RTA - PMMA - Vbar.it
    • Tank Standard For Sputnik RTA - PMMA - Vbar.it

    Tank Standard For Sputnik RTA - PMMA

    €22.95
    Available

    Tank for Sputnik RTA by ING.MODS Aka Paolo Vallone

    Quantity :
    • Original Products Only
    • Fast Delivery
    • Customer Service
    Tank Standard For Sputnik RTA - PMMA

    ________________________________________________

    DESCRIPTION:

    This Tank for Sputnik RTA was designed by ING.MODS aka Paolo Vallone to solve resistance problems 

    in the coupling area of ​​the bell which, in the original version, had 2 o'rings which made the thicknesses of the material

    too thin plastic causing, with use over time, breakage at the relevant hole.

    Here, with the presence of only one o'ring, the shims corresponding to the bell/chimney connection hole are

    far superior and guarantee greater resistance to bending and wear.

    Handcrafted by solid turning from high density and resistance cast PMMA bars with a totally manual process.

    The very tight tolerances verified step by step and the attention to detail, such as chamfers to facilitate

    the insertion of the tank on the deck and extend the life of the two main o'rings,

    make it an excellent and long-lasting product.

    The aesthetics of the atomizer also take on new life with a slide geometry

    more rounded and essential and the transparency of the material.

    The typical opacity of turning processing is visible only when dry, as soon as the tank is put in contact with the liquid

    this frosted effect disappears and becomes transparent with glass.

    ________________________________________________

    INSTRUCTIONS:

    1) Wash the Tank with plain water only to remove any dust (do not use thinners or acetone, the plastic parts would be damaged.

    2) Lubricate the o'rings with a small amount of vaping liquid or chapstick.

    3) When inserting the chimney into the upper hole of the Tank, from below, rotate/swing and push gently at the same time.

    This way the o'ring will not suffer damage due to the sharp edge of the chimney (tight tolerances).

    4) If strong resistance to advancement occurs, do not force the chimney by pushing longitudinally but proceed slowly

    roto-oscillations to overcome the o'ring seat until it stops completely.

    Overthrust could damage the Tank.

    ________________________________________________

    TECHNICAL NOTES:

    Spare o'ring size: 10x1.5mm (OD 13mm, ID 10mm)

    ________________________________________________

    Sold individually.

    Customers who bought this product also bought:

    Tank Standard For Sputnik RTA - PMMA - Vbar.it

    Tank Standard For Sputnik RTA - PMMA

    €22.95